CLEANING A DECK USING HIGH-PRESSURE CLEANING
Sinclair

CLEANING A DECK USING HIGH-PRESSURE CLEANING

When it comes to pressure washing a deck for the first time, one of the most common problems homeowners have is that they typically do more damage than good. If you're a first-timer, don't worry; it doesn't have to be this hard.

Because homeowners believe that greater pressure is better, each pass of the wand often results in severe and ugly damage. People tend to put greater pressure on themselves with each new negative mark in the hopes of erasing the error. People might quickly find themselves in a downward circle of increased pressure and wood damage.

This article would ensure that the process of pressure washing your desk becomes easier.

Effortlessly and safely cleaning a Deck with High Pressure

Examine the deck that needs cleaning. Is the wood older or softer than it should be? Is there a substantial amount of old covering on your deck? Is it a huge or small surface with complex corners? These considerations will aid in determining the proper nozzle, cleaner, and wand distance. A cleaning may be necessary before pressure washing if there is a large accumulation of stains or sealers. When possible, avoid using cleansers since clean water and adequate pressure may frequently do the job just as well. To prevent damaging softer wood, use a greater degree of nozzle and wand distance.

Recognize that pressure washers are a mix of water pressure and flow. Cleaning becomes easier with more flow. 1500 pounds per square inch (PSI) is more than enough for most deck surfaces.

The nozzle's next step is to choose an acceptable fan degree. Typically, decks will need a 25-degree nozzle (for tough build-up) to a 40-degree nozzle (for less resistant build-up) (for newer decks with minor damage or synthetic wood). The lower the pressure at the point of contact, the greater the degree. Before you begin, test a tiny, concealed area to check that your nozzle selection is adequate for your wood surface.

Pressure washing's primary purpose is to remove dirt and debris while leaving no visible traces in the wood or elevated wood fibers. The pressure loosens the dirt while the flow washes it away.

Many individuals are unaware of the power and harm that a pressure washer may cause to a person's body. Make sure you have a pair of hard rubber boots, water-resistant work trousers, and eye protection.

Now is the time to get down to business, and there are a variety of pressure washer attachments that may help make the task go more smoothly. Consider a foaming bottle or lance if you opt to use a chemical to dislodge the grime. With these attachments, you'll be able to apply solutions over vast regions in a short amount of time.

Final thought

It is always advisable to begin sweeping the wand at a constant length and distance from one side to the other. After finishing, let the deck dry thoroughly before inspecting any resistant places. When it's dried, it's much simpler to see any missing or damaged areas. It's critical to read the label on any protective coating or stain carefully. Many will need to dry for many hours before they can be used. Finally, and maybe most significantly, congrats on a job well done.